![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#11
|
|||
|
|||
|
wrote in message
... A 26" 16:9 is almost the same height as a 21" 4:3. Thanks Chip. Bruce. |
|
#12
|
|||
|
|||
|
"RobertVA" wrote in message
... Depending on your distance from the local bradcasters and the configuration and materials in your residence you might be able to get FREE high definition local stations Over The Air (OTA) with an antenna. I'm about 50 miles west of the broadcast tv stations, and in a townhome so a big external antenna wouldn't be allowed. Bruce. |
|
#13
|
|||
|
|||
|
"Bruce." wrote:
wrote in message ... A 26" 16:9 is almost the same height as a 21" 4:3. Thanks Chip. Bruce. Your welcome. BTW, as another poster said, get a bigger one, you won't be disappointed! Chip -- -------------------- http://NewsReader.Com/ -------------------- Usenet Newsgroup Service $9.95/Month 30GB |
|
#14
|
|||
|
|||
|
Bruce,
Find out if the TV stations digital channels are in the UHF band. I thought the idea was to put them all there, so they could free up the VHF (channels 2-13) band for other stuff when the regular TV has to go off the air Feb 2009. But I saw a table somewhere that I think showed some digital channels on VHF. I might be wrong. Anyway, UHF antennas are much smaller than VHF ones, and an indoor one might work OK. All our digital stations here in the Norfolk, VA area are in the UHF band, and I just put up a temporary UHF antenna indoors, and it's working great. It's a Terk TV32. The TV reports S/N ratios around 32, and signal strengths of 98 (out of 100), whatever exactly that means. -- Earl Kiosterud www.smokeylake.com ----------------------------------------------------------------------- "Bruce." wrote in message t... "RobertVA" wrote in message ... Depending on your distance from the local bradcasters and the configuration and materials in your residence you might be able to get FREE high definition local stations Over The Air (OTA) with an antenna. I'm about 50 miles west of the broadcast tv stations, and in a townhome so a big external antenna wouldn't be allowed. Bruce. |
|
#15
|
|||
|
|||
|
Bruce,
Keep in mind that CRT measurments are diagonal of the picture tube, not diagonal of the actual viewable area. Your 19" set is probably really about a 17" diagonal, viewable. LCD measurements, and I think plasma, are actual viewable diagonals. Go with the actual measured diagonal of your 19" set. I agree with the other posters about a larger set. I have a recently acquired Sony XBR1 40" LCD set, and really like it. It's equivalent to about a 32.6" 4X2 set, and looks great on the standard TV I mostly watch. I first bought a Sharp Aquos 45" set because of all the wonderful things I'd heard, but took it back, then bought the XBR1. -- Earl Kiosterud www.smokeylake.com ----------------------------------------------------------------------- "Bruce." wrote in message t... "David" wrote in message et... So the question is, how big of a 16:9 widescreen (measured diagonally) TV do I need to display at least a 21" 4:3 picture? It is actually a little trigonometry. A good approximation is to get a set about 20% larger on the diagonal if you want the height to be the same. Thanks David. That makes it about 25.2" Bruce. |
|
#16
|
|||
|
|||
|
On Thu, 15 Feb 2007 16:22:34 -0600, Bruce. wrote:
So the question is, how big of a 16:9 widescreen (measured diagonally) TV do I need to display at least a 21" 4:3 picture? 26". You are aware there's free HDTV ota. -- Want the ultimate in free OTA SD/HDTV Recorder? http://mythtv.org http://mysettopbox.tv/knoppmyth.html Usenet alt.video.ptv.mythtv My server http://wesnewell.no-ip.com/cpu.php HD Tivo S3 compared http://wesnewell.no-ip.com/mythtivo.htm |
|
#17
|
|||
|
|||
|
Sorry... you're only half right about crt measurements. TV sets (by law) are
listed as viewing area, e.g. 27" is 27" viewable. OTOH... computer CRT monitors are listed by tube size, e.g. 19" is more like 18" viewable. TTUL... John "Earl Kiosterud" wrote in message news:[email protected] Bruce, Keep in mind that CRT measurments are diagonal of the picture tube, not diagonal of the actual viewable area. Your 19" set is probably really about a 17" diagonal, viewable. LCD measurements, and I think plasma, are actual viewable diagonals. Go with the actual measured diagonal of your 19" set. I agree with the other posters about a larger set. I have a recently acquired Sony XBR1 40" LCD set, and really like it. It's equivalent to about a 32.6" 4X2 set, and looks great on the standard TV I mostly watch. I first bought a Sharp Aquos 45" set because of all the wonderful things I'd heard, but took it back, then bought the XBR1. -- Earl Kiosterud www.smokeylake.com ----------------------------------------------------------------------- "Bruce." wrote in message t... "David" wrote in message et... So the question is, how big of a 16:9 widescreen (measured diagonally) TV do I need to display at least a 21" 4:3 picture? It is actually a little trigonometry. A good approximation is to get a set about 20% larger on the diagonal if you want the height to be the same. Thanks David. That makes it about 25.2" Bruce. |
|
#18
|
|||
|
|||
|
Most of what folks are writing in this thread is correct. However, keep in
mind that even without an HD cable feed, you will be able to get some digital feeds, plus there's always digital OTA tv. An inexpensive option to consider is a 27" 4:3 crt tv which will have an ATSC tuner (and QAM). For $200-250 you can get a very nice tv. I picked up a 27" house brand best buy tv (insignia) for about 220 last fall, and it definitely has a better SD pic than any LCD for under $1000. The digital (not HD, there is a diference) pic in 16:9 mode is not huge, although still bigger than your 19 or 21" TV, but is extremely good. Depending on the source, the tv will allow you to select 16:9, 4:3 or zoom viewing modes. Unfortunately, it will generally be fed with a crappy signal at the store, but if you can get them to stick an antenna on it and try an OTA digital signal I think you'll be impressed. "Bruce." wrote in message t... It's been way to long since I did algebra so I'm hoping someone can help me with this. I have a 21" CRT 4:3 TV I need to replace. In looking at LCD flat screens, virtually all sold these days are widescreen 16:9. It may be a long time before I upgrade my cable to HD, so for the immediate future I would be using a widescreen 16:9 LCD TV to display a standard 4:3 TV picture, with the required black bars on both sides (assuming unzoomed). So the question is, how big of a 16:9 widescreen (measured diagonally) TV do I need to display at least a 21" 4:3 picture? Thanks for any help. Bruce. |
|
#19
|
|||
|
|||
|
"Bruce." wrote in message t... It's been way to long since I did algebra so I'm hoping someone can help me with this. I have a 21" CRT 4:3 TV I need to replace. In looking at LCD flat screens, virtually all sold these days are widescreen 16:9. It may be a long time before I upgrade my cable to HD, so for the immediate future I would be using a widescreen 16:9 LCD TV to display a standard 4:3 TV picture, with the required black bars on both sides (assuming unzoomed). So the question is, how big of a 16:9 widescreen (measured diagonally) TV do I need to display at least a 21" 4:3 picture? Thanks for any help. Bruce. Actually, it's geometry rather than algebra. You want a screen with the same height as your CRT display area. Rather than wrestling with diagonals, measure the height of your picture now, tape a tape measure to the store, and measure the height of various LCD screens. When you find a match, you have the size of LCD you want. Now compare brands to get your optimal choice for that size. |
|
#20
|
|||
|
|||
|
"Earl Kiosterud" wrote in message news:[email protected] Bruce, Keep in mind that CRT measurments are diagonal of the picture tube, not diagonal of the actual viewable area. Your 19" set is probably really about a 17" diagonal, viewable. LCD measurements, and I think plasma, are actual viewable diagonals. Go with the actual measured diagonal of your 19" set. I have a ~10 year old Sony 32 " CRT set. The diagonal measures precisely 32 inches. Anyhow, a real HDTV smaller than 26 inches is hard to find, if at all. 720P resolution is all you need in a screen that small. Tam |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question on picture size | PhotoGuy | High definition TV | 6 | March 26th 06 02:14 AM |
| Question about sacd and 5.1 | George | Home theater (general) | 9 | February 22nd 06 09:36 PM |
| Dish size question. 10 foot Vs. 12 Foot | Jay | Satellite tvro | 5 | September 12th 05 07:36 AM |
| So complicated... Question about Toshiba 57HX83 versus Hitachi 57G500 | Melandre | High definition TV | 3 | December 11th 03 05:04 AM |
| Samsung 50" DLP size question | beachwalker54 | High definition TV | 0 | November 6th 03 12:56 PM |