![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
|
Hi guys,
I have a DirectTV receiver setup in my garage that sends the AV feed via RG6 coax cables that were prewired when the house was built to all the rooms in the house. Now I bought a projector, Optoma DV10, which only has the following inputs: RGB, S-Video, composite video, component video, HDTV compatible. Basically, my problem is connecting the AV signal from my coax wall outlet to my projector, which does not have any coax input. What do I need to connect from the coax wall outlet to the projector to get both video and audio? I am surprised that there are no modulators on the market that do this type of conversion. I think RadioShack has an RF modulator that takes RGB to coax, but I need the other way around. I know that I can probably do wireless from the receiver to the projector, but I have too much interference. Thanks in advance for any help. Gary |
|
#2
|
|||
|
|||
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| coax input broke off HDTV | [email protected] | High definition TV | 13 | October 31st 05 03:13 AM |
| HDTV Tuner Output to Multiple TVs Over Coax | John T | Home theater (general) | 10 | February 13th 05 09:11 PM |
| Is splitter necessary? Series 2 has coax and RCA I/O | JonesR | Tivo personal television | 2 | September 15th 04 02:10 AM |
| Is splitter necessary? Series 2 has coax and RCA I/O | JonesR | Tivo personal television | 0 | September 15th 04 01:56 AM |
| Combine Tivo CH 3 signal w/OTA on same coax? | Bob Violence | Tivo personal television | 12 | April 28th 04 04:29 PM |