|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
|
Thread Tools | Display Modes |
|
#1
March 30th 04, 12:30 PM
|
|||
|
|||
TUTV Card Arrives
The card arrived in this morning's post.
It cannot be used immediately because the software update would appear only to run at night, so the card must be left in the slot and the box left on standby. One mistake that I made...for old Philips box users, the gold part of the card must point upwards! -- MESSAGE ENDS. John Porcella 
|
|
#2
March 30th 04, 12:47 PM
|
|||
|
|||
|
Think we should leave the STB ON as opposed to Standby overnight. Little
confusion here! Noel "John Porcella" wrote in message ... The card arrived in this morning's post. It cannot be used immediately because the software update would appear only to run at night, so the card must be left in the slot and the box left on standby. One mistake that I made...for old Philips box users, the gold part of the card must point upwards! -- MESSAGE ENDS. John Porcella
|
|
#3
March 30th 04, 12:47 PM
|
|||
|
|||
|
Think we should leave the STB ON as opposed to Standby overnight. Little
confusion here! Noel "John Porcella" wrote in message ... The card arrived in this morning's post. It cannot be used immediately because the software update would appear only to run at night, so the card must be left in the slot and the box left on standby. One mistake that I made...for old Philips box users, the gold part of the card must point upwards! -- MESSAGE ENDS. John Porcella
|
|
#4
March 30th 04, 06:01 PM
|
|||
|
|||
|
"Noel Thomas" wrote in message ... Think we should leave the STB ON as opposed to Standby overnight. Little confusion here! No confusion at my end. The instructions clearly state "on standby", though it states that it must be left on one of two channels! Perhaps the card forces the decoder on, or the update can be done whilst on standby? -- MESSAGE ENDS. John Porcella
|
|
#5
March 30th 04, 06:01 PM
|
|||
|
|||
|
"Noel Thomas" wrote in message ... Think we should leave the STB ON as opposed to Standby overnight. Little confusion here! No confusion at my end. The instructions clearly state "on standby", though it states that it must be left on one of two channels! Perhaps the card forces the decoder on, or the update can be done whilst on standby? -- MESSAGE ENDS. John Porcella
|
|
#6
March 30th 04, 07:53 PM
|
|||
|
|||
|
"John Porcella" wrote in message ... "Noel Thomas" wrote in message ... Think we should leave the STB ON as opposed to Standby overnight. Little confusion here! No confusion at my end. The instructions clearly state "on standby", though it states that it must be left on one of two channels! Perhaps the card forces the decoder on, or the update can be done whilst on standby? Definately should be left ON. Apparently there is an insert in the later cards they have been sending out with a note stating the mistake. -- MESSAGE ENDS. John Porcella
|
|
#7
March 30th 04, 07:53 PM
|
|||
|
|||
|
"John Porcella" wrote in message ... "Noel Thomas" wrote in message ... Think we should leave the STB ON as opposed to Standby overnight. Little confusion here! No confusion at my end. The instructions clearly state "on standby", though it states that it must be left on one of two channels! Perhaps the card forces the decoder on, or the update can be done whilst on standby? Definately should be left ON. Apparently there is an insert in the later cards they have been sending out with a note stating the mistake. -- MESSAGE ENDS. John Porcella
|
|
#8
March 30th 04, 08:18 PM
|
|||
|
|||
|
Hi John,
We must have different instructions!! The first green inst box (step 8) says," ..... However you must leave your stb ON overnight on a TopUp channel." Step 9 says"..... Your stb will automatically switch to Standby." (I am aware of Step 6 but understand that it has a typo. Regards Noel "John Porcella" wrote in message ... "Noel Thomas" wrote in message ... Think we should leave the STB ON as opposed to Standby overnight. Little confusion here! No confusion at my end. The instructions clearly state "on standby", though it states that it must be left on one of two channels! Perhaps the card forces the decoder on, or the update can be done whilst on standby? -- MESSAGE ENDS. John Porcella
|
|
#9
March 30th 04, 08:18 PM
|
|||
|
|||
|
Hi John,
We must have different instructions!! The first green inst box (step 8) says," ..... However you must leave your stb ON overnight on a TopUp channel." Step 9 says"..... Your stb will automatically switch to Standby." (I am aware of Step 6 but understand that it has a typo. Regards Noel "John Porcella" wrote in message ... "Noel Thomas" wrote in message ... Think we should leave the STB ON as opposed to Standby overnight. Little confusion here! No confusion at my end. The instructions clearly state "on standby", though it states that it must be left on one of two channels! Perhaps the card forces the decoder on, or the update can be done whilst on standby? -- MESSAGE ENDS. John Porcella
|
|
#10
March 30th 04, 08:24 PM
|
|||
|
|||
|
"Noel Thomas" wrote in message ... Hi John, We must have different instructions!! The first green inst box (step 8) says," ..... However you must leave your stb ON overnight on a TopUp channel." Step 9 says"..... Your stb will automatically switch to Standby." (I am aware of Step 6 but understand that it has a typo. Regards Noel It make more sense leaving it on. How did that error creep through? -- MESSAGE ENDS. John Porcella
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Sky Digital FAQ - updated 31/10/2004 for new "Freesat" FTV cards | Jomtien | UK sky | 0 | January 2nd 05 07:42 AM |
| Sky Digital FAQ - updated 31/10/2004 for new "Freesat" FTV cards | Jomtien | UK sky | 0 | December 19th 04 10:43 AM |
| Sky Digital FAQ - updated 31/10/2004 for new "Freesat" FTV cards | Jomtien | UK sky | 0 | December 12th 04 08:36 AM |
| Sky Digital FAQ - updated 31/10/2004 for new "Freesat" FTV cards | Jomtien | UK sky | 0 | December 5th 04 07:55 AM |
| Sky Digital FAQ - updated 31/10/2004 for new "Freesat" FTV cards | Jomtien | UK sky | 0 | November 28th 04 07:18 AM |
Linear Mode
